Trying to check my valve clearances on GS500F.
Watched the online video and have the Haynes manual.
I'll probably have more questions, but where do you get a gasket for the valve cover???? And how much would one cost... And I noticed it says to replace o-rings etc... when you check things, where do you get the sizing and how do you buy those, do you just take them to an auto store?
So far I've taken off the fairings and gas tank, and I noticed there might be an oil leak around the right side of the valve cover. It's quite oily, it was dark out so I didn't get a good look and I packed up for the day... but I'm assuming it needs a new gasket? I'll get some pics up hopefully tomorrow nite.
Also, where would I get tubes that fit for a carb synch? I bought a stretch of vinyl tubing from CT but it was too big to fit over the vacuum stuff.
The annoying part is I have a bike only... hard to get around.
Thanks, total newb at this.