I just finished cleaning my carbs. Of course when I was tightening the very last main jet the screwdriver slipped and i took a bit off the jets flathead gap. The damage is on the outside of the jet but I want to get opinions on the damage and if it will affect anything.
Here all the 800X600 Pics - the High Res ones are located at the links below.
2nd Question: I was very careful to keep all of the components organized so they would go back in their proper spots. However I just realized I put the diaphragm components on the wrong carb body. ie 4-3-2-1 instead of 1-2-3-4.
Note that the the spring, cover and diaphragm were all moved together so the full set from carb body 1 is now on carb body 4. All of the components were in very good condition. I am weary of undoing the work unless its necessary as a lot of the diaphragm screws are on the verge of stripping. I will be syncing the carbs once everything is back together.
Is this going to be a problem?
High Res Shot:
Ultra High Res Shot: