So I installed Heli-bars on the bike, and now I have a conflict with the front brake lever. The only position it will work in means the lever is too flat, too parallel to the ground, I like (need) it more angled down.
But, the hose, where it makes a 90 degree bend hits the fork or the bolts on the upper triple. Very frustrating.
It looks like if I could re-angle the hose out of the 90 degree bend, I could then have the room to angle the bar down, but I dont know if you can and in any event, there is a tab there.
Is that greenish nut turnable to change the angle of the hose? and if so, what's with that tab? its trapped!
Can I cut that tab?