So I finally set up my T-Rex stand today cause I needed to lube my chain. Anyways, setup was frustrating as hell. Everytime I tighten the bolts, despite putting weight on the wheels to plant them on the ground, the wheels on one side start to come off the ground...anyways, I finally tighten the bolts just enough so it's tight but not enough to get the wheels off the ground so that is now level with the ground...except now the friggin' right side is tilted inwards!!! (it was tilted BEFORE I even put the bike on the stand) Not sure if during manufacture they made a boo-boo or what, but as you can see from the pics below, the two sides are not even!!! Anyways, I finally managed to get the bike on the stand, and the welds itself seem pretty good. So my question, is this a major problem that the two sides are not even? Or will it eventually crack the stand or my spools? Thanks in advance!