Got these from http://store.ledoption.com/default.asp but on ebay.
Just have to say - pull the fuse when replacing front seat roof lights... metal ring on LED bulb blew the fuse when installing! 2 out of 6 bulbs dead. Not sure why. One lasted 3 mins then died. Other DOA. Other 4 work great. For rear interior light use thin screwdriver to pry out bulb lense. Front lights, pull down with thin screwdriver on cover that looks like two small speakers are inside below sunglasses holder. Then remove two torx T20 screws. Yank down light. Replace bulbs from rear not inside lense. Clear bulb cover removes easy with entire fixture pulled down dangling from wiring. Use thin blade slot screwdriver to pry lense off. DO NOT overtighten these torx screws on reassemlby. Very thin plastic they thread into!
These in cool white for interior
These for the rear plate in blue
Note: If I did it again I'd get the slightly brighter (emitters on sides too) LED's vs the ones I got which are decent bright. Also the ones with emitters on sides would look nicer in headlight housing but haven't replaced those yet. Here's brighter ones: http://store.ledoption.com/LED...0.htm
LED 1W emitter on left, OE bulb on right. About the same brightness overall.