Bought a new throttle assembly - twist grip body/tube and a new kill switch. Was originally going to have EMS put this on for me, but booked a trip this summer so that cash went there.
The throttle part of it I'm sure I can figure out - it's just attaching and rerouting the throttle cables so it shouldn't be that hard. Pop the tank off and find out how everything works.
I'm leery of the electrical part (not that comfortable with electrical stuff) - the kill switch assembly. Racer guys, have you mounted one of these aftermarket units on your bikes?
Is it difficult figuring out which wire goes where?
Soldering tool is prob required as well?
Thanks in advance.