2006 R1 project
SOLD TO DEVIN THANKS!!!!
Hope it's ok to post a project in this forum?? It is more than a complete bike, just not assembled??
Located up in PG.
I have enough stuff to build 1 1/2 bikes and then some... no registration as I was going "ubuilt"
I'll try and remember all the bits:
06 engine/trans, 12000 kl's no damage
06 engine /trans 3000 kl's, head rashed
1 swing arm
rear coil over and bracketry
1 set of forks
2 tanks with pump or pumps? cant remember if I have 2 pumps? One tank dented a bit...
new "take off" wheels
new mich tires
new HD Chain
new "take off" sprockets plus spares
new aftermarket levers
new bar end mirrors
rad and fans and hoses
a couple of sets of calipers /rotors
clip on handle bars 1 or 2
aftermarket handlebar and riser mounts for custom install
new extended brake hoses etc for raised bars
new "takeoff" stock exhaust
a couple of damaged stock exhausts
05 ECU (no transponder key needed)
New aftermarket comp programmer
pegs/controls and some extra bits
a couple of front fenders
all hardware plus extra bits
a bunch of fairing bits, just never payed much attention as I was going naked anyways...
That's all that comes to mind....
Moving to Rankin Inlet NU and I would rather sell than put into storage.
Was asking $3000.00 but will look at offers too.
250 613 5335 text/call or email firstname.lastname@example.org
Last edited by mikeyapproved; 01-08-2011 at 05:26 PM.