The final day of the WCSS is coming up fast and I think I'm nearly done prepping my SV. The fairing is mounted, I've drilled and wired the front caliper bolts, the fork drain bolt, oil bolt, oil filter, oil cap, and siliconed the break line bolts and front axle. But I'm stuck on how to drill and wire the exhaust nuts+bolts and the rear axle. Since there's a nut it doesn't make any sense to drill through it and the axle since all it would take is 1/32 to turn it out of line.
I was hoping someone would be willing to take a look over the bike before Thursday to make sure I'll pass tech on saturday (assuming I'm allowed to race) and give me some pointers on how to wire this thing up.
I can bring the bike to you if you're willing to take a look.