Hey folks, this is essentially the most ridiculous DIY out there but I figured somewhere out there someone might wonder how to install one of these.
Also I wanted to write up a review of the Competition Werkes shorty slip on for the 03-05 R6.
So here we go.
Things you will need:
- 11mm socket or 11mm wrench
- Allan key set
- Damp cloth to wipe the disgusting dirt that you cant get at with the stock exhaust on
- I used a micro fibre cloth to wipe down the stainless steel Competition Werkes pipe after install to get the finger prints off
- Beer if available but not necessary
This is roughly how it came minus me cutting the tape
Some stickers and instructions it came with
So at the base of the pipe you will see this bolt, use the 11mm socket and crack that sucker loose
Save the passenger foot peg mount for second so you can just pull the pipe right off and not have it crash down on your beer if you loosen the base bolt second. This also uses the 11mm socket
After you pull the stock pipe off you will need an allan key to remove the spacer here
Then put the new slip on pipe on and tighten that sucker on and enjoy! Ill be doing a sound clip of it and a review for those who are curious, when I get back from Vernon that is.