I read the instructions and saw the videos, I know how it is supposed to go, but I am stuck on one of the last steps of installation and could use some help
I am on step 7 in the instructions, part where I need to tighten the nut to the rod: http://www.moto911.com/pdf/750-4119....hvd6us7qpj8872
Issue that I have is that I dont have a socket that can fit inside the tube to hold nut from rotating with the rod while i torque it down. It is a 17mm socket for that nut but every 17mm socket that I found is too fat to go inside the tube. 15mm on the other side works great, but for the life of me I am not sure how to tighten this damn thing now.
In the pictures underneath step 7 I can see that he has a tool inside that tube and that he is holding a nut with it, but I have no idea what he is using.
Does anyone know of any low profile sockets? If you installed it on your bike, how did you go about this? Any help is much appreciated.