so i've ran into this issue a couple of times, I purchased tires off the internet and once arrived and installed we're having a hard time getting proper bead in..
the 1st time i had this was on the R1 rear tire, the old man just pumped it with higher psi, i think 65psi did the trick to get it to bead in and seal right..
now I just got new tires on the Raider S, took it to the dealer and they ran into the same issue!! arrgghh!! unfortunately they do not have a cage in the shop and due to WorkSafe BC issues they cannot pump any higher!!
it sat in the sun this afternoon and they got 55psi in there but no full bead yet!
i'm planning on putting the stupid rear tire out in the sun all day tomorrow hoping it will better, which it has been getting better after being in the sun..
now, for those of you who have run into this, what is there to do about it? i have a compressor at home but i dont know if i wanna just pump the thing and chance it blowing up...
i'm open to suggestions, usual shop is not available at this point so i'm on my own!!
is this the only trick ??