I've never had this many parts off of the bike before. I finally managed to get all the exhausts off the bike. One was a bitch in particular and it must've taken me an hour to finally remove it. Now that I have access to all these places the exhausts were obstructing... I want to clean the bike thoroughly. The problem is the cylinders are open now. I've got some tin foil covering it at the moment to prevent any small pieces of gunk from flying inside but I was wondering if I should take some more precautions. What I WOULD like to do is spray the thing down with a hose but I think that's probably not a good idea seeing as how water could get inside the cylinder and I'm not sure that water + electronics is a good idea. Any suggestions other than cleaning it all by hand with a brush and towel?