TOP DOLLA AUDIO! focals n u-dimension
WHOLE SETUP - $3700 OBO
U-dimension pro series version 10.4 - $1200 OBO
U-dimension pro series version 2k1 - $1200 OBO
U-dimension pro V.ll (0.5 Farad) Capacitor - $600 OBO
Focals 33v (2) incl enclosure - $600 each OBO
PICTURES UPON REQUEST!
pm me only please!
Specs can be found @http://www.u-dimension.jp/u-dimension/index.htm.
Specs for 10.4
This is the largest 4 channel amp in production from U-dimension. MINT condition with original packaging, and receipt. Also a very underrated amp. Made in Japan.
105 RMS x 4 @ 4 ohms
165 RMS x 4 @ 2 ohms
315 RMS x 2 @ 4 ohms
S/N: 105 dB
Dampening factor: 300
Variable crossovers for front and rear
CH. Separation 60 db
Freq. Response 20 Hz-50 Hz
Input Sensitivity 200 mV-7V
Input Impedance 10K ohm
Fuse Rating 40 A x 2
Dimensions Depth 460 mm
Width 270 mm
Height 60 mm
Specs for 2K1
This is the largest mono amp in production from U-dimension. MINT condition with original packaging, and receipt. . Made in Japan.
1 Channel Amplifier
700 Watts RMS at 4 Ohms
1300 Watts RMS at 2 Ohms
2000 Watts RMS at 1 Ohms
Frequency Response: 15 Hz - 250 Hz
THD 0.50 % (80 KLPF)
S/N Ratio 75 dB
Input Sensitivity: 150 mV - 7V
Input Impedance: 10K Ohms
Damping Factor: 200
Operating Voltage 11 - 16 Volts
Crossover: 50 Hz - 250 Hz, 12 dB /Oct, Low pass
Crossover: 15 Hz - 40 Hz, 18 dB /Oct, Subsonic
Bass control optional
Dimension (D x W x H)mm : 308 x 57 x 550
Specs for (0.5 Farad) Capacitor
MINT condition with original packaging, and receipt. . Made in Japan.
Capacity 500,00 uF
Size: W 270 mmxH 60 mm x 271 mm Terminal
4 Gauge IN/OUT Protection is available
The capacitor installed immediately to an amplifier side! Today, although that to which mainstream capacitor is carrying out the cylindrical form is most, since forms with amplifier differ greatly, the distance of an attachment position will open. Since u-Pro 0.5F have the same type as the power amplifier of pro series, installation of them is possible in piles, and they can connect a cable by the shortest. Moreover, since synthetic resistance is extremely lowered by being parallel and connecting 92 pc of capacitor with few 4,700 uF accuracy errors sorted out, it is rash, and electric charge and electric discharge are transparent and can enjoy sound in a large image with depth. The necessity for Capacitor The power supply of a car is united with the number of rotations of engine, always changes, and is not stable in 12V. Yes, it is necessary to supply the stable power supply to a good quality of sound system. Then, since a power supply can be accumulated and set if capacitor is installed, even if the voltage of a battery falls, sufficient power supply can be supplied to amplifier in an instant.
Focal 33v * (2)
13" Polyglass 33 v Subwoofer for bass-reflex enclosure Woofer 33 v
MINT condition with original packaging, and receipt.
330 mm (13) subwoofer
3" (77 mm) v.coil
Max. Power handling: 800W
Nominal power handling: 400W
Sensitivity (2.8 V/1m) 94.5 dB
Frequency response: 30 Hz - 1 Hz
Folding diameter 288 mm mounting depth 149 mm
Sealed enclosure (l.) - Bass-reflex enclosure (l.) 30 - 60 liters
Last edited by Diesel Rocket; 12-16-2003 at 01:10 PM.