i have recently brought a Honda VFR 800 engine including the wireing loom,
but whit out the dash all the buttons,lights etc.
Just 1 mcu and one big cable harness and 4 bobines etc.
i wanted it to start.
But like always it doesn't do that,
can any one help a bit.
i allready found 1 think but i don't know if it is correct.
My starter relay has 2 screws and 4 pins.
- on 2 of that pins there is 12v and on the other 2 don't. the loom uses only 3 but internally there is power on 2 (connected to B) the other 2 are already internally connected is this true..??
- when i measure the ohms between the + pair and the other i don't measure
any resistance..?? is this correct..??? (they are not connected neither)
- the kill button does it affect the above measureing?? whit other words..
if you shut down the engine whit it has the relay a memory funcion of it..???
- what kind of coulour has the kill switch connector???
if i chock the relay i hear a tick???
does a bike from this year 1998 or 2000 has any crash sensors..??? which i might need to renew or connect tho the loom.
it would be beautiful if any one could help to give me info
- like start button connector
- info starter relay
- kill switch connector
TKS you should try to dig up a wiring diagram as your first step.
The first thing I'd do is put some switches on the wires that connect to the starter and the kill switch. (or just wire the kill switch into the "on" position)
Next I'd see if the start actually spins when you apply current directly to it.
If you hear a "click" when you apply power to the relay that probably means the relay is working fine. The relay should have a small diagram on the side that describes what pins do what.
" on 2 of that pins there is 12v and on the other 2 don't. the loom uses only 3 but internally there is power on 2 (connected to B) the other 2 are already internally connected is this true..??"
Sorry I don't understand what you are trying to say here... but try the above steps. Be methodical and test each piece one at a time.
When I put the wiring on my r6 back together the headlights wouldn't come on. After careful investigation with a multimeter i determined the fuse was missing
the problem is now that i don't get a spark.
When i aply 12volts to a yellow line the relay klicks and the starter intends to start the bike and you hear the typically bike sound..yeahh that works fine.
the kill switch is the problem i dunno wich wire it is.
can you help me obtaining a wireing diagram..??/