Sorry guys if I posted in the wrong forum, but can the mods please keep this here until i get some help. Thanks
Ok here's the story. We helped a friend change the oil and spark plugs on his 1991 Honda CBR 600 F2. After finishing, we started it up to see if there were any leaks or anything and it started up fine. Then we take it for a boot and it still ran fine, up until about 4 blocks later he started losing power and when he gave it more throttle the bike wouldnt accelerate anymore. So we pulled over to the side and tried starting it again. The bike will crank, but just wont start. Anybody have any ideas what the problem is?
PS. We took out the gas tank to check if there was any fuel getting into the engine and when we took it off we turned it on the ON position and no fuel came out of the tank. Is this normal? Any help would be greatly appreciated.