I am painting my tank and fenders and as gearing up with a spray gun and booth is cost prohibitive I have been using spray cans. Because I was afraid of getting runs in the paint I suppose I wasn't spraying the paint thick enough and as a result the paint has orange peel.
Tomorrow I plan on masking and spraying the 2nd colour and I assume there will peel in this colour as well.
To remove should I wait until paint is fully cured and wet sand carefully, then polish.
Is 600 grit fine enough sand paper and what do I use to polish the paint again. I have the "Mothers 3 step" polish system that I have used on my car.( seems too easy)
Do you normally have to sand the line between different colours with a two tone paint.