Wellllllll, I was so happy that there was minimal dammage to my bike when i dropped it. So far from the truth! I went to replace the generator cover and when I pulled it off a PIECE OF THE BLOCK FELL OFF! I guess the impact broke the lip of the generator housing at the bottom. Ofcourse this part had to be aluminum and be one cast piece included in the lower half of the block.
The good news is that it's not load bearing just more of a sealing surface. I think i'm going to have the welded but I haven't have anyone look at it yet. Anyone seen this before? Any other suggestions? There is a shuffle pin on the piece that broke off.
This sucks a$$,