Hey folks, I got the Factory Pro 1.7 (the AMA big boy kit!!) jet kit for the beast.
The instructions are marginal at best but I have a factory and a Haynes manual so it should be ok. The part I am fuzzy on is the boring out of the carbs.
The boring out is for the main air jet. The instructions say to drill out with 3mm bit, tap w 3mm bit, screw in 3mm allen bolt, lever out and tap with 5mm tap.
Question is, what the hell do they mean my lever out? Is there a sleeve, or are the air jets normally not removable and you are therefor pulling them out? Will this be more obvious once I take the carbs off?
I'll be ordering a Factory Pro ignition advancer for a few more fractional ponies.
Thanks in advance!