Before the warm weather gets here I would like put some new oil in my forks. I already spoke with Rod from RMR Suspensions about how much oil and what weight to use, but I am wondering what the process is like? From what I read in the manual, when I undo the top caps, the damper rod will come out as well, then I can just pour out the old fork oil. I will put some new oil in, compress the fork to flush it around and then drain that. I know the amount to put back in is 110mm from the top, fully compressed, no spring. But what settings will I lose from doing this? Rod said my bike was set up really well and not to change anything. Will I lose any rebound or even preload settings? If not the preload is easy enough to see where its at. I would like to make sure that my setup is the same after doing this.