Routing Woodwork
Results 1 to 1 of 1

Thread: Routing Woodwork

  1. #1
    Registered User Array Chumly's Avatar
    Join Date
    Jun 2004
    Honda & Suzuki

    Routing Woodwork

    Can anyone help me with routing (corner round bit) the edge of some precut lengths of ½” MDF? It's just a simple curve and I’m using it for custom baseboard trim. Hopefully near the Tri Cities and I can bring the lengths of precut MDF to your shop anytime. I also need some 3/4" MDF plinth blocks routed I've already cut to length.

    I tried running it through my router table on my table saw but my router died, also and it was kind’a hard to get the lengths to hand feed at an even speed and run evenly.

    Much thanks,

    Last edited by Chumly; 07-18-2006 at 05:44 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts