Just thought I would share the polish job I did to my stock R6 exhaust can. I would just go out and buy an after market pipe, but me so poor. Usually I dont like polish jobs on anything, but Ive seen this done before and it looks good to me. Anyhoo.. I used the following items to complete the polish:
1000 grit wetdry sand paper
2000 grit wetdry sand paper
Mothers mag wheel polish
Total cost of stuff was $49.86 from Lordco. It would have been cheaper if I had realised that I had picked up a $10 roll of masking tape.
Took me about 6 hours to do. Man are my fingers and wrists sore. lol.. Can't wait to see it back on the bike.
Here are the pictures...