OK here is a question. I did some research and I could not figure it out yet.
I installed a HID light in my CBR 600RR.
I thought I was smart and changed the highbeam/lowbeam.
So now the highbeam (right side) is constantly on and I can turn on and off the much brighter HID in the low beam reflector (left side). So far noone seems to be pissed of about that and I was driving against my bike and it's not distracting.
Here is the problem. If I turn on the HID it does not go on the first time. If I turn of and back on then it works. After a few minutes it starts to flicker and turns itself off.
I checked all the connections and it seems fine. The ballast is wired straight from the highbeam output (no relay or extra switch).
• Do I need a relay??
• Or is the ballast not working properly?
• Any other ideas or thoughts?????