I have an 89 rz, got it 6 months ago. drained & replaced trans oil with good synth stuff. top end was done 5K ago but the cooling system needed to be flushed big time (4X actually). New plugs now installed, old one looked good.
going for a 250KM ride for the 1st time.
plugs, basic tools, duct tape, wire, multitool etc
Any advice on other stuff to take? Can I just pretty much nail it to 6-7K at 110-130KMS for an 45 min to an hour, then stop for gas & repeat?
When I stop for gas, should I let it cool right down (lunch etc) or should I fire it up & take right off?
Help would be appreciated, I love this bike so much but have been entertaining the idea of a 4 stroke (did I just say that????) Thanks (in advance) for any help