[Digi168]

Flush mount turn signals, is anyone using these and if so what brand and how good are they. I want to replace my rear ones as the high pipe will not allow for the stock signal. How much and where to get them locally.

Thanks

 

[adamantium]

You may get a little more than me in the back because your rear tail section is wider. However, unless you mount LP flushmounts alone the side, or use some smaller led lights somewhere near the break light, your visitibilty will be poor for turning right.

My Micron came with a kit to move the stock tail lights (which weren't on, and arn't on) a little lower so it was under the pipe.

 

[Digi168]

I thought of moving it under the pipe, but I have a new idea to mount them where the plate is now and lower the plate an inch or so, I have a drawing I am working on, can you get the lights locally?

 

[adamantium]

RMS carried everything I needed. The super skinny blinkers I haven't seen in stores though, nor do they look like they're really that visible to begin with.

 

[TeeTee]

You could go with flush mount bullets or you could try mini stalks. Here are my new mini stalk on the 9R. The first pic attached to this post shows the lights and the license plate for a good size reference.

 

[TeeTee]

As you can see from the above they are set so they just stick out either side of the plate. The lens is only about 1 1/4 x 2 so they are quite small.

And here is a pic showing the custom plate I made to mount them so they only stick out as shown above. A plate could be made to let you mount similar lights low, high or one of each if need be to avoid the pipe.

Note that the license plate fits from tight to the bottom edge of the brake light down to the lower edge of what's left of the rear fender. So you can see the lights are quite small.