BC Sport Bikes Forum banner
1 - 4 of 4 Posts

·
Swivel on it
Joined
·
11,659 Posts
Discussion Starter · #1 ·
So i need a new set of frame sliders for the F4i. The ones i had/have bolted to the engine mounts (through holes in the fairing). I've been offered a set of vortex sldiers - would these be a straight replacement, or do they bolt in a different location?
 

·
Registered
Joined
·
121 Posts
that all depends i know theres a couple of different places you can mount them i had to cut holes through the plastics it didnt look to bad
 

·
Registered
Joined
·
1,012 Posts
So i need a new set of frame sliders for the F4i. The ones i had/have bolted to the engine mounts (through holes in the fairing). I've been offered a set of vortex sldiers - would these be a straight replacement, or do they bolt in a different location?
I would assume they mount in the same place, I just installed my new vortex sliders on my RR today, relatively easy, used the laser method to mark the holes. I came across pictures of the vortex install on the F4i, have a look at this page Alex and see if you can make any comparisons

http://www.cbrforum.com/m_55748/tm.htm
 

·
Swivel on it
Joined
·
11,659 Posts
Discussion Starter · #4 ·
Yep - same place mine are in. Should work a treat. Thx :)
 
1 - 4 of 4 Posts
Top